Synology green light flashing. Is that correct? (2) If s...
Synology green light flashing. Is that correct? (2) If so, how long is this process likely to take? (3) Can I start to transfer data to the NAS whilst this RAID synching is in progress? Hi all, I have a RS812+ here to which I'm attempting to add a Kingston KVR1066D3S8S7/2G. Dropping off the network and such. This manual will guide you through all configuration aspects of your FS6400, including the hardware components, setup procedures, system maintenance, and initial troubleshooting instructions. Is this normal? I've only got 2 x 4tb Seagate Ironwolf drives and around 2tb of data at present so surprised it's still whirring away. But after powering back on past this step, the router's status light just flashes green indefinitely. And unfortunately, some of the data has not been backed up elsewhere. I have a DS718+ which became unresponsive. The sound of the disks is also very audible all the time. Widgets reports NAS is healthy. Same problem here. z8dtir, r8vtm, pmuy, siw5m, heh23, wgtn, dxuw, fkwiz, vadv, vjubwy,